Instructions / Assembly

Table Of Contents

ASSEMBLY

INSTRUCTIONS

7/1 5

Preparing part 1

Align the pre-drilled hole in part 1,

screw in the cam bolt A and tighten

by screwdriver S.

Connect part 3,4,5,6 to the part 1

1) Align the hole in the part 1, insert the part D into the hole by hand;

2) Align the hole in part 3, insert the part D and cam bolt A at the

same time, then put nut B and tighten by screwdriver S

3) Cover the nut B by part J for good looking.

4) Repeat the same way to finish part 4, 5, 6.