Instructions / Assembly

STEP-19
Key:
1.Short press: Cycle switch white light, warm light, neutral light.
2.Long press: When the light is on, press the button to adjust the
brightness without releasing it. Release the button to lock the
brightness.
Key:
1.The initial state is off.
2.Press the first button to enter the steady state. (Induction function
does not work in steady on mode and will not be automatically
extinguished)
3.Press the second button to enter night mode. (The light body flashes
three times to prompt, and then enters the night induction mode after
the mountain finishes.)
4.Press the third button to enter daytime induction mode. (The light
body flashes twice as a prompt, and then enters the daytime mode)
5.Press the fourth button to return to the closed state and so on.
Human body induction mode special description:
1.Set [night] induction mode, under the condition of sufficient light, the
lamp will not light up when it senses people, only under the condition
of insufficient light and sensing people will automatically light up.
2.Set the induction mode [during the day], whether the light is sufficient
or not, the lamp will automatically light up when it senses people.
3.After people leave the induction area, the lamp will be automatically
extinguished in about 25 seconds.
4.If the person keeps moving in the sensing area, the light will keep on.
Special note:
Please fully charge before first use.
ASSEMBLY INSTRUCTIONS
24/29