Operation Manual

7
EN
Section 2
Getting Started
Loading the Battery
Before using the camera, users must load the Lithium-ion
rechargeablebatterycomewithinthepackage.
Insertthebatteryaccordingtothecorrectpolaritymarks(+or1.
-).
Closethebatterycoverrmly.2.
Charge your battery
YoumustusethesuppliedACchargerortheUSBcable.
ThecameramustbeturnedOFF;blinkinglightconrmscharging,andthe
light becomes constant when the charging has been completed.
(In AC charging Mode, the light will turn itself off automatically after 3~5
minutes.Thefullchargetimeisabout3to4hours.)
Inserting and Removing an SD Card (Optional)
The camera comes with aninternal memorywhich allows you to store photos andvideos.You can
expandthememorycapacitybyusinganoptionalSDmemorycard.
Insertthememorycardintotheslot.Pleaserefertothegureon1.
the right side.
ToremoveaninstalledSDcard,pressthecardinwardstorelease2.
it.
When the card pops out, gently remove it from its slot.3.
Recommendedmemorycapacity:1GBorabove.4.
Note
Whenamemorycardistted,videos/photosaresaved•
onthecardratherthanonthebuilt-inmemory.
Protecting Data on an SD Card: SD Card is read-only •
when it is locked. No photos or videos can be recorded
when the SD card is locked. Make sure the lock is on
the writeable position before recording any media.
Writeable
position
Write-Protected
Position