User Manual

T940-HOM-004-Module
integration
manual_Rev4.docx
Date:
November 21, 2016
FCC
The OEM integrators are responsible for ensuring that the end-user has no manual instructions to remove or
install module.
The module is limited to OEM installation ONLY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
These following instructions/statements shall be reported on the User Manual:
Any changes or modifications to this equipment not expressly approved by JAY electronique may cause,
harmful interference and void the FCC authorization to operate this equipment
This equipment complies with FCC’s radiation exposure limits set forth for an uncontrolled environment under
the following conditions:
1. This equipment should be installed and operated such that a minimum separation distance of
20cm is maintained between the radiator (antenna) and user’s/nearby person’s body at all
times.
2. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The RF module has been certified for mobile and fixed applications. If the module will be used for portable
application the device must undergo SAR testing and the following instructions shall be reported on the User
Manual.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
If SAR measurement is not required:
This portable equipment with it’s antenna complies with FCC’s radiation exposure limits set forth
for an uncontrolled environment. To maintain compliance, follow the instructions below :
1. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2. Avoid direct contact to the antenna, or keep contact to a minimum while using this equipment.
If SAR measurement is required:
This portable equipment with it’s antenna complies with FCC’s radiation exposure limits set forth
for an uncontrolled environment. This equipment has shown compliance with FCC’s Specific
Absorption Rate (SAR) limits. To maintain compliance, follow the instructions below :
1. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.