User's Manual

T940-HOM-004-Module
integration
manual_Rev3.docx
Date:
April 24
th
2014
24-04-2014
Labelling
!! Warning !!
“This transmitter module is authorized to be used in other devices only by OEM integrators
under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is
maintained between the radiator (antenna) & user’s/nearby person’s body at all times.
2. The transmitter module must not be co-located with any other antenna or transmitter.”
Moreover, the host equipment must be labelled as follows:
“Contains Transmitter Module FCC ID: OQMSA”
Finally, the host equipment must precise the following warning:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
Information Note
This modular is used exclusively by Jay Electronique.
The OEM integrators are responsible for ensuring that the end-user has no manual instructions to
remove or install module.
This module and the antennas must be professionally installed.
A specific ferrite must be attached to the AC line; here its characteristics below:
 Brand name: Laird Technologies
 Product reference: 28B0686-200
 Number of turns: 2
“THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY
THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT.” According to FCC Part 15.21