Integration Manual

Page 8 / 19
7 FCC STATEMENT
The OEM integrators are responsible for ensuring that the end-user has no manual instructions to remove or install
module.
These following instructions/statements shall be reported on the User Manual:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Caution: the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for general population.
This device must not be co-located or operating in conjunction with any other antenna
or transmitter.
The radio module must be labelled as follows:
FCC ID: OQMS5
Moreover, the host equipment must be labelled as follows:
Contains FCC ID: OQMS5, Model S5, IC: 3393A-S5
Warning:
This module is used exclusively by JAY Electronique. This product and the antennas must be professionally installed.