User's Manual
Troubleshooting Guide Sight Adjustment
11
6
Firing Operation
7
Safe
To Fire the pellet
1) Switch the selector switch to Semi or Full Auto
2) Pull the trigger
Caution
Semi Auto
•
Confirm your shooting area is safe before firing.
• There are possibilities that no BB comes out after pulling the trigger. This may
happen when a new magazine is inserted. Switch to Full Auto and firing 5 – 10 shots
will solve this problem.
• Charge the battery if the firing cycle become slow.
• Give the airgun a rest of 5 – 10 minutes after firing 220 rounds in order to ensure long
service lives of the motor and battery.
• If bullets are clogged, stop firing and remove the clogged bullets immediately.
• Service the airgun with silicon oil as daily maintenance.
• Hop up may be unstable for first 200-300 rounds after silicon oil is used, this is
normal operation of the gun
.
Long Distance Sight
Status Cause Action
Press
Press the adjust button and slide it forward
or backward. The larger the number, the
longer the distance to the target
Short Distance
Front Sight: Adjust the sight clockwise for
higher sight point or anti-clockwise for lower
sight point
Fire selector is set to Safe Set the fires selector to Semi or Full Auto No operation at all
Battery is not charged Fully charge the battery
Battery connector is disconnected or
reversed
Connect the connector correctly
Fuse is fall off or blown down Replace the fuse
Poor Motor electrical connection Check and repair the motor
Expired Motor Life Replace a new motor
Magazine is not full seated into the
receiver
Load the magazine into receiver and turn
the gear wheel. If still doesn’t work,
contact your service technician or ask us
for assistance
Although the motor is
running, but no BB fire
out
Bullets are clogged in Hop up system or
barrel
Using the cleaning rod to remove clogged
bullets
Faulty gear
Please contact your service technician or
ask us for assistance
Tappet plate is broken
Insufficient battery power Charge the battery Full auto not
functioning
Fault bullets feed from magazine Using the cleaning rod to remove clogged
bullets
Deviation in gear timing Fire 5-6 rounds in full auto then switch
back to semi auto again
Insufficient battery power Charge the battery
Semi auto not
functioning
Fault bullets feed from magazine Using the cleaning rod to remove clogged
bullets
Hop up or barrel damaged Please contact your service technician or
ask us for assistance
BB roll out from barrel
Faulty or poor quality of BB Use higher quality BB
Full Auto
Hop up or barrel damaged
Piston or O-ring damaged
Shooting distance
greatly reduced
Please contact your service technician or
ask us for assistance
Deteriorated piston spring
Gear problem caused by excessive dry
firing
Faulty BB Bullets
Damaged dear Please contact your service technician or
ask us for assistance
Loud operation noise
Problem caused by engagement between
the motor and gears
Don’t tune the engagement between the
motor and bevel gear yourself, contact
your service technician or ask us for
assistance
Gun has been
immersed by water
Stop Operation immediately and disconnect the battery. Wipe off any excess water
from inside the body and from the battery. When AEG is completely dry, test fire. If no
operation or signs of malfunction is suspected, please contact your service technician
or ask us for assistance