User's Manual

Command Line Interface
Diagnostics and Identification Commands
35www.javad.com
Software =Ver. 1.8 Rev 04 B24
BootLoader =Ver. 3.0 Rev 03
BT addr =00:18:D7:00:3C:C7
5.2. STATE
The STATE command is used to check the state of the wireless link, the unit in the link, and the alarm
control lines. To specify a radio unit (local or remote), the CONNECT command must be used in prior of
STATE command using.
STATE [Parameter Name] [Parameters List] [/?]
The STATE command without Parameter Name indicates all values as shown below:
RSSI =-141 dBm
BER =0E-0
FREQ = 225.000000 MHz
CHAN =-4
TEMP =32
SYNC =0
MODE =FIXED
VHPA =11.75 V
BT =ON
Parameter
Name
Parameter List
RSSI -15 to -137 dBm - Indicates the Receive Signal Strength in dBm
BER 0 to 9.9E-3 - Indicates the BER level
FREQ 215.000000 to 255.000000 MHz - Displays the central frequency of the operating
channel
TEMP -30.C to 100.C. Displays the temperate inside of enclosure.
SYNC 0 - if link is not established yet
1 - indicates the link established
MODE AUTO/FHOP/FIXED
VHPA VCC V
BT ON/OFF