User's Manual
Table Of Contents
- HPT225BT*
- Table of Contents
- Preface
- FCC Class A Compliance
- Canadian Emissions Labeling Requirements
- Industry Canada
- WEEE Directive
- Introduction
- Configuration
- Command Line Interface
- Specifications
- Safety Warnings
- VHF Radio Usage
- Warranty Terms
Command Line Interface
Serial Interfacing Commands
32 www.javad.com
The response of command without Parameter Name indicates all values:
RATE =0
BITS =8
PARITY =NONE
FLOW =NONE
DTR =0
RS =RS232
DATATX =UART
DATARX =UART, BT
3.2. MPORT
The MPORT is an object that responsible for maintenance serial port interface configurations such as data
rate and number of bits in a byte.
MPORT [Parameter Name] [Parameters List] [/?]
Note:
JAVAD GNSS radio modem’s does not support data flow and parity on the maintenance serial port.The
radio modem with none-dedicated maintenance serial port must keep CTS line always active in MPORT
mode (DP/MP is low).
DATARX 0 - UART, a default setting
1 - USB
2 - BT
Parameter Name Parameter List
RATE 0 – Auto.
1 – 1200 baud
2 – 2400 baud
3 – 4800 baud
4 – 9600 baud
5 – 14400 baud
6 – 19200 baud
7 – 38400 baud
8 – 57600 baud
9 – 115200 baud, a default setting
Parameter Name Parameter List