User's Manual

Command Line Interface
Diagnostics and Identification Commands
INFO
25www.javad.com
4.5. Diagnostics and Identification Commands
4.5.1. INFO
The INFO command is used to retrieve the Radio ID along with its Hardware version, the loaded real-
time software version/revision and BootLoader’s version/revision.
INFO [Parameter Name] [Parameters List] [/?]
The INFO command without Parameter Name indicates all values:
FH915 Spread Spectrum Radio Modem.
Product ID =41
S/N = 11327
Hardware =2.0
Firmware =2.1.9
BootLoader =4.03
4.5.2. STATE
The STATE command is used to check the state of the wireless link, the unit in the link, and the alarm
control lines. To specify a radio unit (local or remote), the CONNECT command must be used in prior of
STATE command using.
STATE [Parameter Name] [Parameters List] [/?]
The STATE command without Parameter Name indicates all values:
Parameter Name Parameter List
ID Product ID
SN Six bytes Serial Number (SN)
HW 1.0 – hardware revision
FW Ver. 1.0 Rev. A – displays software’s version in numeric “Major.Minor” format and
revision in numeric format (range from 01 to 99) for engineering releases and alphabetic
format (A to Z) for manufacturing releases
BL BootLoader Version
Parameter Name Parameter List
TTL1 0/1 – State of TTL_IN1 line
TTL2 0/1 – State of TTL_IN2 line
RSSI -52 to -116 dBm – Indicates the Receive Signal Strength in dBm
BER 1.0E-6 to 9.9E-3 – Indicates the BER level
FREQ 902.000000 to 928.000000 MHz – Displays the central frequency of the
operating channel
CHAN 1 to 9601 – Displays the selected or currently scanned frequency channel
TEMP -30°C to 100°C – Displays the temperature inside of enclosure