Technical data

9
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always disconnect it from the mains when you do not use
it and before assembling / disassembling or when cleaning.
• Take care with the blade of the stick and the chopper because
both are very sharp.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTIONS OF USE
• Remember that when you place or replace the accessories, the blender must be
disconnected from the mains.
• To insert the stick (5), the whisk accessory (6) or the chopping bowl lid (9) into the body
(4) make coincide the indication ( ) placed in the accessory to insert with the indication
( ) placed in the body. Next turn the accessory to the ( ) position till the end to
leave it correctly fixed.
• To release the accessories, turn it till the indication ( ) coincide with the indication
of the body ( ).
• Put the stick or the whisk accessory into the foods and press the power pushers having
in mind that:
Pusher 1: Minimum power.
Pusher 2: Medium power.
Pusher 3: Maximum power.
• Keeping pressed the pushers 1 and 2, at the same time, you will get a medium-high
power.
CHOPPER
• Bear in mind that you must remove previously from the foods, the bones, pips, etc.
• Cut the food into pieces. Some food like raw meat, cheese, etc. has to be cut in
2 x 2 cm approximately.
• Place the blade (8) into the shaft of the chopping bowl (7).
• Place the lid (9) into the body (4) as showed in the paragraph “instructions of use” and
insert the set in the chopping bowl.
• Be sure the lid is correctly fixed in the bowl.
• Make work the chopper in an intermittent way.
• During the functioning keep the chopping bowl lid (9) hold by the hand.