USER GUIDE

Troubleshooting

505

VBS3Fires v3.6.3 User Guide

28.5 VBS3 Pause and Resume

28.5.1.1 When a scenario is paused in the VBS3 2D view on the event that the 'ESC' key

is pressed, the scenario will resume

- When the simulation timers are paused from VBS3Fires by clicking on the pause button in

the Simulation Status panel and if the user moves on to the 2D view of VBS3 and the escape

key is pressed the mission will be resumed, hence enabling the timers to resume again.

28.6 Effects in VBS3

28.6.1.1 Craters disappear in VBS3 when more rounds of DPICM is fired

There is a maximum number of craters which VBS3 will handle in a certain session. This is defined in

a variable called MaxPermenantCraters in the VBS3.cfg file which could be found in the following

path;

%USERPROFILE%\Documents\VBS3. This variable is by default set to 200. When the number of

craters in the terrain becomes greater than this amount VBS3 clears all the craters which are less

than the specified value (e.g: less than 200) in the terrain and creates the new craters if a new COF is

carried out. By setting this variable to a desired higher value this issue can be solved.

28.6.1.2 Illum Effects in high wind situations

In a scenario with a high ground wind speed, the ILLUM timed rounds should drift with the wind.

28.7 Sim Studio

28.7.1.1 Sim Studio does not display correctly

Sim Studio requires a feature that is supported only on Windows 7 and upwards.