USER GUIDE

Entering a Call-For-Fire

154

VBS3Fires v3.6.3 User Guide

In the Fires Instructor Control Panel, select a Battery and select an FO. Provide all necessary settings

for a fire mission and execute.

During this opened mission, select the same Battery and a different FO required for the concurrent

fire mission, provide all necessary settings for a fire mission and execute.

A new mission will be created in the mission table for the same active Battery and the second FO.

The mission table would display two missions created for the same Battery that is active in missions

being carried out by both FOs.

Image 7.133 Instructor Control Panel – Mission table

At a given time when two fire missions are executed for the same Battery by two different FOs, the

second fire request would fire after all the rounds of the first fire request are completed. This

method of fire mission allocation is applied for When Ready, At My Command, Do Not Load and

Can’t Observe.

In the case of providing two ‘Time On Target’ fire mission requests, the TOT mission with the

shortest time will be fired first followed by the TOT fire mission with the longer time.

A Battery will be able to fire at one target, switch to another and then revert to the original in order

to fire both missions. If it cannot achieve the fire mission tasks, it will inform the instructor that it is

unable to fulfill both Fire Missions to which it has been assigned.