USER GUIDE

Entering a Call-For-Fire

VBS3Fires v3.6.3 User Guide

manually send the command to the ICP. Immediately after the Fire command is received by the ICP,

the fire mission will commence.

7.2.1.3 Do Not Load

If the instructor’s ‘Trainee Calls for Fire’ panel receives a DNL command from trainee, the instructor

is required to send it to the ICP manually. Then the command is received by the ICP. The instructor is

supposed to click Execute in ICP. The fire mission will not commence until the Cancel DNL command

is received by the ICP.

At this point the trainee should send Cancel DNL command from the Adjustment panel which is

received by the instructor’s ‘Trainee Calls for Fire’ panel. Following the same process the instructor

should manually send that command to the ICP. Immediately after the Cancel DNL command is

received by the ICP, the fire mission will commence.

7.2.1.4 Time on Target

If the instructor’s ‘Trainee Calls for Fire’ panel receives a TOT command from trainee, the instructor

has to manually send it to the ICP. Once it is received by the ICP instructor should click Execute in

ICP. But the firing is not commenced until the specified time is reached.