Instructions / Assembly

• The range may be installed flush to the rear wall. Install a non-combustible material

on the rear wall above the range and up to the vent hood. It is not necessary to install

non-combustible materials behind the range below the countertop height.

• The minimum vertical clearance between the appliance and combustible construc-

tion extending from the cooking surface is 30 inches.

• The minimum vertical clearance between the countertop surface and combustible

construction above the appliance is 18 inches.

To prevent the range from tipping forward, the anti-tip brackets must be installed.

Failure to install the Anti-Tip Bracket will allow the range to tip over if excessive

weight is placed on an open door or if a child climbs upon it. Serious injury might

result from spilled hot liquids or from the range itself.

ANTI-TIP BRACKET

WARNING: DO NOT OPERATE THE RANGE WITHOUT THE ANTI-TIP

BRACKETS IN PLACE. IF THE APPLIANCE IS ACCIDENTALLY TIPPED,

THE WEIGHT OF THE RANGE MAY CAUSE SERIOUS INJURY.

There are Two Tip-Over Brackets

which are to be installed at the back

of the range, on the left and right

sides.

At the back of the range, insert and tighten a Bracket Bolt into the reinforced hole

at the bottom of the right-side panel.

Afﬁx the Right Bracket into the wall behind the range using 2 Wall Anchors and 2

Screws and positioning the bracket so that it will line up on top of the Bolt to

engage.

Repeat steps 1 and 2 for the Left side of the range.

Safely tilt the front of the range upward slightly and slide the range back towards

the two brackets on the wall, so that the brackets engage.

Try to slide the range forward slightly to verify the Anti-Tip device has been prop-

erly installed. The range should not tip more than 4 inches from the wall if correct-

ly installed.

Ensure the anti-tip device is re-engaged when this appliance is moved.

Screws Wall Anchors Bracket Bolts

Left

Bracket

Right

Bracket

Bolt

Right

Bracket

Gas Pressure

Regulator

• The minimum distance from the side of the range above the countertop to combus-

tible sidewalls must be at least 13 inches.

• The minimum horizontal distance between overhead cabinets installed to either

side of the appliance shall not be less than the nominal width of the appliance.

• A floor-supported unit requires zero distance between adjacent combustible

construction (sides and rear).