Instructions / Assembly

12
• The range may be installed flush to the rear wall. Install a non-combustible material
on the rear wall above the range and up to the vent hood. It is not necessary to install
non-combustible materials behind the range below the countertop height.
• The minimum vertical clearance between the appliance and combustible construc-
tion extending from the cooking surface is 30 inches.
• The minimum vertical clearance between the countertop surface and combustible
construction above the appliance is 18 inches.
HOOD / COMPOSITE OVERLAY INSTALL
It is recommended that the unit be set under a powered, overhead, vented exhaust
hood of sufficient size and capacity.
The bottom of the hood should be 30” minimum to 36” above the countertop. This
would typically result in the bottom of the hood being 67” to 73” above the floor.
These dimensions provide safe and efficient operation of the hood.
LEVELING
The Front Vent Panel at the base of the range can be removed by unscrewing to
access the 4 adjustable legs. Adjust the range to desired height by rotating the legs
clockwise to raise and counterclockwise to lower. The range height can be raised 1.5”
(40mm).
30" (762mm) min
36" (914mm) max
67" - 73"
(1700mm)
(1852mm)
37"
938mm
30" (762mm) min
36" (914mm) max
Countertop Countertop
Metal HoodMetal Hood
WALL INSTALLATION
Wood/ Composite Overlay
ISLAND INSTALLATION
Wood/ Composite Overlay
37"
938mm
67" - 73"
(1700mm)
(1852mm)
• The minimum distance from the side of the range above the countertop to combus-
tible sidewalls must be at least 13 inches.
• The minimum horizontal distance between overhead cabinets installed to either
side of the appliance shall not be less than the nominal width of the appliance.
• A floor-supported unit requires zero distance between adjacent combustible
construction (sides and rear).