Full Product Manual

GAS SUPPLY REQUIREMENTS

• Installation and service must be performed by a qualiﬁed installer.

• The range has been equipped and adjusted for use with natural gas (NG) at manu-

facture.

• For use with liquid propane (LP) gas, the range must be properly adjusted by a qual-

iﬁed installer. The appliance has been supplied with a liquid propane (LP) Conversion

Kit. Each oriﬁce has been clearly identiﬁed on the oriﬁce packaging to identify with

which burner it corresponds with. Refer to the ‘PARTS’ section of this manual for a

table listing oriﬁce sizing.

• Ensure the gas appliance pressure regulator has been set for the gas which the

appliance will use. The gas appliance pressure regulator is located at the bottom

right, rear of the range.

• Installation of this range must conform with local codes, or in the absence of local

codes, the National Fuel Gas Code, ANSI Z223.1 / NFPA 54. This range has been

design-certiﬁed according to CSA/ANSI Z21.1/CSA 1.1:2018 Ed.2+E2019 latest

edition.

• A statement of the maximum gas supply pressure in accordance with the inlet pres-

sure rating of the gas appliance pressure regulator supplied.

MINIMUM GAS SUPPLY PRESSURE TO APPLIANCE FOR NATURAL GAS (NG) – 7.0

IN.W.C.

MINIMUM GAS SUPPLY PRESSURE TO APPLIANCE FOR LIQUID PROPANE GAS (LP)

- 11.0 IN.W.C.

APPLIANCE REGULATOR IS SET AT 5.0 IN. W.C. OUTLET PRESSURE.