Manualshelf

Full Product Manual

ManualsBrandsJANSKA ManualsAppliances36 in. 5.2 cu. ft. Gas Range with 6-Burners, Convection Oven, Griddle, and 2-Sets of Knobs and Handle in Matte Black
11121314151617181920
ELECTRIC POWER SUPPLY REQUIREMENTS
• Your range must be electrically grounded in accordance with local codes or, in the
absence of local codes, in accordance with the National Electrical Code (ANSI/NFPA
70, latest edition). A copy of this standard may be obtained from the National Fire
Protection Association.
• The power supply must be the correct polarity. Reverse polarity will result in
continuous sparking of the electrodes, even after flame ignition. If there is any doubt
as to whether the power supply has the correct polarity or grounding, have it checked
by a qualified electrician.
• Use 120V, 60Hz, properly grounded branch circuit protected by a 15-amp or
20-amp circuit breaker or time delay fuse.
• A separate circuit, servicing only this appliance is required.
WARNING: Never use reductions, shunts, extension cords or adapters which can
cause overheating or burning.
• Place the power outlet so that it is accessible after the appliance has been installed.
WARNING: Disconnect the appliance from the main power supply before installation
or service.
GROUNDING
• The power cord is equipped with a three-prong (grounding) plug which mates with
a standard three-prong grounding wall receptacle to minimize the possibility of
electrical shock hazard from the range.
WARNING: DO NOT cut or remove the grounding prong from the power cord.
• Where a standard two-prong wall receptacle is encountered, it is the responsibility
and obligation of the customer to have it replaced with a properly grounded
three-prong wall receptacle by a licensed electrician.
• All cord connected appliances shall include instructions relative to location of the
wall receptacle and a warning to the user to disconnect the electrical supply before
serving the appliance.
WARNING: Make sure the AC Supply cable does not come in contact with any parts
or components that get hot.
• The manufacturer is not liable for any direct or indirect damage caused by faulty
installation or connection.
Area allows for flush
installation with
through-the-wall
connection of pipe stub
/ shut-off valve and rear
wall 120V outlet.
Area allows for flush installation
with through-the-floor connection
of pipe stub / shut-off valve.
Shortest connection from
hard pipe stub location to
range hook-up.
14