Full Product Manual
2
5
4
3
1
To prevent the range from tipping forward, the anti-tip brackets must be installed.
Failure  to  install  the  Anti-Tip  Bracket  will  allow  the  range  to  tip  over  if  excessive 
weight is placed on an open door or if a child climbs upon it. Serious injury might 
result from spilled hot liquids or from the range itself. 
ANTI-TIP BRACKET 
WARNING: DO NOT OPERATE THE RANGE WITHOUT THE ANTI-TIP 
BRACKETS IN PLACE. IF THE APPLIANCE IS ACCIDENTALLY TIPPED, 
THE WEIGHT OF THE RANGE MAY CAUSE SERIOUS INJURY. 
There are Two Tip-Over Brackets 
which are to be installed at the back 
of the range, on the left and right 
sides. 
At the back of the range, insert and tighten a Bracket Bolt into the reinforced hole 
at the bottom of the right-side panel. 
Affix the Right Bracket into the wall behind the range using 2 Wall Anchors and 2 
Screws and positioning the bracket so that it will line up on top of the Bolt to 
engage. 
Repeat steps 1 and 2 for the Left side of the range. 
Safely tilt the front of the range upward slightly and slide the range back towards 
the two brackets on the wall, so that the brackets engage. 
Try to slide the range forward slightly to verify the Anti-Tip device has been 
properly installed. The range should not tip more than 4 inches from the wall if 
correctly installed.
Ensure the anti-tip device is re-engaged when this appliance is moved. 
6
Screws Wall Anchors Bracket Bolts
Left
Bracket
Right
Bracket
Bracket
Bolt
Right
Bracket
Gas Pressure
Regulator
13










