User Manual

35
v Close the zipper and spread the fabric open at with
the right side facing up.
Attach the Zigzag foot A.
Adjust the stitch length to 4.0, stitch width to 2.5 (default
value) and the thread tension dial to 1-3.
Baste the opened fabric and zipper tape together.
i Basting stitch
o Zipper tape
i
o
v
b
n
m
b Attach the zipper foot E with the left pin.
Adjust the stitch length and the stitch width to default
value, and thread tension dial to “4”.
Backstitch across the end of the opening 0.7-1 cm
(3/8˝) and turn the fabric 90 degrees.
!0 0.7-1 cm (3/8˝)
CAUTION:
Be sure that the needle does not strike the presser
foot or zipper teeth when the zipper foot is attached.
n Stitch through the garment and zipper tape, guiding
the zipper teeth along the side edge of the foot.
Stop the machine 5 cm (2˝) before the foot reaches
the slider on the zipper tape. Lower the needle into
the fabric, and raise the foot. Remove the basting
stitches.
!1 5 cm (2˝)
!2 Basting stitches
m Open the zipper, then lower the foot and stitch the
remainder of the seam.
After sewing is nished, remove the basting stitches
on the upper fabric.
!3 Basting stitches on upper fabric
!2
!1
!0
!3