Use and Care Manual

29
n The buttonhole is sewn in the sequence as shown.
When the buttonhole is nished, the machine will stop
automatically with the needle in the up position.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is nished, do not raise the foot or
buttonhole lever, simply start the machine again.
n
m
,
!0
!1
m Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
!0 Pin
!1 Seam ripper
, When buttonhole sewing is nished, push the
buttonhole lever upward as far as it will go.
y Buttonhole lever
y
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density (refer to page 30).