Tus neeg siv phau ntawv

2. Be sure to have the following items:
• A new lens gasket (P/N R0451101 for Jandy
Pool Light and P/N R0400501 for Jandy Spa
Light).
• One (1) new lamp. See Table 1 for
specications.
Replace the lamp with one of the same type and
wattage. Failure to replace the lamp with one of
the same type will damage the light assembly and
may cause an electrical hazard resulting in death
or serious injury to pool or spa users, installers, or
others due to electrical shock, and may also cause
damage to property. Be sure the power is switched
OFF before removing or installing lamps. Allow lamp
to cool before replacing.
WARNING
3. To remove the light assembly, unscrew the special
pilot screw at the top of the face ring, remove light
assembly from niche and gently place assembly on
the deck. It is not necessary to drain down the pool
or spa. See Figure 1.
Section 2. Operating Instructions
2.1 To Operate the Light
Activate the light by either turning on the switch, setting
a program, or by pushing the button on a pool and spa
controller.
Section 3. Replacing The Lamp
Always disconnect the power to the pool or spa
light at the circuit breaker before servicing the light.
Failure to do so could result in death or serious
injury to serviceman, pool or spa users or others due
to electrical shock.
WARNING
1. Turn off the main electrical switch or circuit
breaker, as well as the switch, which operates the
underwater light.
Jandy Model
Fixture
Voltage
Lamp
Voltage
Lamp
Wattage
Lamp Type
Qty. per
Fixture
Lamp Kit
Part Number
Pool/Spa White Light 12 Volt AC 12V 100 Watt R20 Flood 1 R0450501
Pool White Light 120 Volt AC 120V 300 Watt R40 Flood 1 R0450502
Pool White Light 12 Volt AC 12V 300 Watt R40 Flood 1 R0450503
Pool White Light 120 Volt AC 120V 500 Watt R40 Flood 1 R0450504
Spa White Light 120 Volt AC 120V 60 Watt 1 R0450505R20 Flood
Table 1. Lamp Specications
Figure 1. Removing the Pool and Spa White Light Assembly for Lamp Replacement
1
POOL WALL
POSITIONING TAB
TAB LOCATOR
Power
Cord
Niche
PILOT SCREW
Push up on
bottom of
light assembly
2
Power
Cord
Niche
SPA WALL
Unscrew pilot screw
and pull top of light
assembly away from
spa wall
1
PILOT SCREW
Push up on
bottom of
light assembly
2
POSITIONING TAB
TAB LOCATOR
Unscrew pilot screw
and pull top of light
assembly away from
pool wall
SPA WHITE LIGHT
ASSEMBLY
POOL WHITE LIGHT
ASSEMBLY
Bonding
cable
Bonding
cable
Page 5
ENGLISH
Jandy
®
Pro Series Underwater Pool and Spa White Lights
|
Operation Manual