User's Manual

1. The motor slide may require adjustment after machine has been in service. Loosen jam nuts using provided wrench.

Using feed handles, position motor/slide assembly in the full up position. Using supplied hex key, equally turn

adjustment screws clockwise to increase slide tension or counterclockwise to decrease slide tension. Do not over tighten

adjustment screws. Excessive slide tension can damage the machine. Properly adjusted, the motor/slide assembly

should have no side to side movement and remain in the fully up position without drifting down.

2. Keep bottom of magnet clean, free of chips, burrs, nicks, oil and other contaminants. Inspect magnet face

to ensure surface is flat and square. A worn magnet surface dramatically reduces magnetic holding force.

3. Periodically lubricate motor slide ways with lithium base grease.

5. Arbor runout should not exceed .0035 inches per revolution. This is most accurately measured by placing a dial

indicator needle inside of arbor bore and rotating arbor while observing indicator.

6. Inspect motor brushes and replace as needed.

7. Replace any worn parts and regularly tighten fasteners that have become loose during usage.

8. Regularly test machine by placing machine on non-ferrous material. Engage magnet switch. Motor should not continue

running when motor on button is released.

regular maintenance

dimensions and specifications

Height 21"

Width 8"

Length 12"

Weight 36-1/4 lbs.

Motor 1.6 HP 1200W (single phase)

120V / 10.2A ~ 240V / 5.1A

210 / 420 RPM (no load)

Spindle Bore #2 morse taper

Arbor Bore 3/4"

Drill Point Breakaway 1111 lbs. on 1" plate

Magnet Base Dimensions 3-1/2" x 8"

Magnet Dead Lift 2657 lbs. on 1" plate

Slugger Cutter Diameter (Maximum) 2"

Slugger Depth of Cut (Maximum) 2"

note: magnetic base requires 1" minimum material thickness when drill-

ing 1-3/8" and larger diameter holes