User's Manual

EN301893 V1.6.1 (2011-11),
EN301908-1:V5.2.1(2011-05), -2 V5.2.1
EN 300 440-1 V1.6.1/-2 V1.4.1,
EN 301 511 V9.0.2
EN301 489-1(V1.9.2(2011-09))/ -3 V1.4.1/ -7 (V1.3.1(2005-11))/
-17(V2.2.1(2012-09))/-24(V1.5.1:2010),
EN 55022: 2010
EN 55024: 2010
EN 62311: 2008
EN 50360: 2001 / A1: 2012
EN 62209-1 : 2006 / -2 : 2010
EN 62479 : 2010
EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011
EN 50332-2: 2003
Australia AS/NZS 4268:2012
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions. The user may find the following booklet helpful: “Something about
Interference.” This is available at FCC local regional offices. Our company is not responsible for
any radio or television interference caused by unauthorized modifications of this equipment or
the substitution or attachment of connective cables and equipment other than those specified by
our company. The correction is the responsibility of the user. Use only shielded data cables with
this system.