User's Guide

Mobile Device User Guide
5
Attach the handstrap
1. Separate the velcro of the handstrap.
2. Feed the loose end of the extended handstrap through the handstrap holder.
3. Wrap the handstrap around the holder and fasten together to close the strap.
Install the battery
1. If battery cover is installed on the device, slide the battery latch to the left.
2. The battery cover will lift up slightly, grasp the battery cover and remove it.
3. Insert the battery, left side (with golden contacts) first, into the battery
compartment.
4. Press the battery down until the battery fully rests on the bottom of battery
compartment.
5. Put the battery cover back, tab first, and press down until the latch secure
the battery cover.
Charge the battery
Cradling the device
1. Sliding the device into the cradle with slight angle.
2. Slightly push the device back.
3. The device is sitting on the cradle in a secure mode.
To charge the device using the Single-Slot Cradle
1. Connect the power supply to the cradle. Make sure the cradle LED is green.
2. Put the device on the cradle.
3. Charging status LED on device.
4. The LED will illuminate to confirm connection (off indicates not charging, orange
indicates charging, green indicates fully charged and red indicates fault).