JSS4-VC2 WARNING: Improper installation could result in damage to the amplifier. Read all instructions before installation.
Introduction Your JSS4-VC2 Speaker Selector-Volume Control is designed to operate with up to 4 pairs of loudspeakers of 4, 8, and 16 Ohms impedance in any combination. It can be used with one or two stereo amplifiers, or with 4 Channels of a surround-sound type sound system. Each of the 4 output Control channels can be individually switched to the amplifier connected to A INPUT, or one connected to the B INPUT.
Using Push all ON-OFF switches that will be used in to ON. Initially, best results will probably be obtained with all AMPLIFIER A-B switches, out at A. Set the volume control for what is likely to be the loudest location at maximum (fully clockwise), and the rest about halfway down. Turn the HI-FI system on, and adjust its volume for normal listening level at the loudest location. Then adjust the volume for the remaining locations to a satisfactory loudness.
The scope of the warranty The warranty period will come into force as from the purchase date stated on the invoice. The warranty will apply for the following period of time: 2 years for electronics (power supply, amplifier, etc.) 7 years for other parts (cabinet, speaker units, etc.) In case of warranty inquiries, please contact your dealer. In case of request for service under warranty, please enclose your original receipt.
