SDS

IDH number: 701941 Product name: Fast Cure Epoxy HARDENER
Page 3 of 5
Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER
Aluminium hydroxide
10 mg/m3 TWA (as
Al) Total dust.
1 mg/m3 TWA
Respirable fraction.
15 mg/m3 TWA (as
Al) Total dust.
5 mg/m3 TWA (as
Al) Respirable
fraction.
None None
Polymercaptan hardener None None None None
2,4,6-Tris(dimethylaminomethyl)phenol None None None None
Distillates, petroleum, heavy thermal cracked None None None None
Styrene
20 ppm TWA
40 ppm STEL
100 ppm TWA
200 ppm Ceiling1
600 ppm MAX.
CONC 5 minutes in
any 3 hours
None None
Silica, amorphous, fumed, crystal-free
10 mg/m3 TWA
Inhalable dust.
3 mg/m3 TWA
Respirable fraction.
20 MPPCF TWA
0.8 mg/m3 TWA
None None
Ethylene glycol
100 mg/m3
Ceiling1 Aerosol.
None None None
Benz(a)anthracene
Included in the
regulation but with
no data values.
See regulation for
further details.
Exposure by all
routes should be
carefully controlled
to levels as low as
possible.
None None None
Engineering controls:
Provide adequate local exhaust ventilation to maintain worker exposure below
exposure limits.
Respiratory protection:
Use a NIOSH approved air-purifying respirator if the potential to exceed
established exposure limits exists.
Eye/face protection:
Safety goggles or safety glasses with side shields.
Skin protection:
Chemical resistant, impermeable gloves.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state:
Paste
Color:
Black
Odor:
Mercaptan
Odor threshold:
Not available
pH:
Not applicable
Vapor pressure:
Negligible
Boiling point/range:
> 149 °C (> 300.2 °F)
Melting point/ range:
Not available
Specific gravity:
1.4
Vapor density:
Not available
Flash point:
> 93 °C (> 199.4 °F) Tagliabue closed cup
Flammable/Explosive limits - lower:
Not available
Flammable/Explosive limits - upper:
Not available
Autoignition temperature:
Not available
Evaporation rate:
Not available
Solubility in water:
Slight
Partition coefficient (n-octanol/water):
Not available
VOC content:
0.04 % (value for resin and hardener together)