Operating Guide
OPERATION AND SAFETY MANUAL
Warranty
Jameson products carry a warranty against any defect in material and workmanship for a period of one year from date of shipment unless failure is due to
misuse or improper application. Jameson shall in no event be responsible or liable for modications, alterations, misapplications or repairs made to its products
by purchaser or others. This warranty is limited to repair or replacement of the product and does not include reimbursement for shipping or other expenses
incurred. Jameson disclaims any other express or implied warranty.
BB_MO4
Part Number Buddy® Model
11-38-400M 400’ X 1/2” Big Buddy
11-38-500M 500’ X 1/2” Big Buddy
11-38-600M 600’ X 1/2” Big Buddy
11-38-800M 800’ X 1/2” Big Buddy
11-38-1000M 1,000’ X 1/2” Big Buddy
11-38-1500M 1,500’ X 1/2” Mega Buddy
Part
Number
Accessories - Sold Separately
11-38-RK Repair Kit
2 Splice Ferrules, End Ferrule, Emery Cloth, Adhesive,
Canvas Pouch
11-139 Swivel Eye Attaches pull line to rod
11-141 Roller Guide
Guides rod around bends, sweeps, misalignments,
wires
11-142 Shackle Fitting
Use with swivel eye for larger pulling loop to attach
pulling eye
11-143 Swivel Coupling Connects two rods; provides rotation
11-148 Rod Grapple Set Connects two rodders from opposite directions
11-25-6ST 6’ Stinger Tip
Guides rod through bends, sweeps, misalignments
11-25-8ST 8’ Stinger Tip
11-140 Splice Repair Kit Splice Ferrule, Adhesive, Emery Cloth
11-146 End Ferrule Repair End Ferrule, Adhesive, Emery Cloth
11-AWK Wheel Kit All-Terrain Kit (2 wheels/axle)
Grapples
Roller
Guide
Shackle
Stinger Tip
Swivel Eye
Swivel
Coupling
Repair Kit
All Terrain Wheel
• DO NOT USE ON LIVE CIRCUITS. DISCONNECT POWER. Metal tip on rod.
• Wear safety glasses and gloves.
• Keep rod inside reel when not in use. Out-of-control rod can harm personnel or property.
• Keep rod clean. Some contaminants (including water) can conduct electricity.
• Keep secure footing. Protect yourself from falling should pulling eye move suddenly or separate from rod.
• Check for rod damage prior to use. Cracks, gouges, nicks, or white stress marks on jacket or sharp bends will weaken rod.
Injury could result if rod breaks while pulling.
• Do not use slip joint pliers, locking pliers or powered pulling equipment on rod.
• Do not force a pull that is stuck. Remove wires and check for kinks or obstructions.
• Avoid pulling rod over sharp edges.
• Do not bend rod beyond 10” radius.
WARNING - ADHESIVE
Read manufacturer’s instructions before using adhesive. In case of eye contact, ush with water and seek medical atten-
tion If skin contact occurs, apply solvent (such as nail polish remover) to area and gently remove adhesive. Wash solvent
off with water. Solvents should not be used in case of contact with eyes or open wounds.
Always wear safety goggles (ANSI Std. Z87.1) and gloves when working with adhesive and/or unprotected berglass rod.
See adhesive product label for Safety Data Sheet (SDS).