SDS

WLL-L0502
SAFETY DATA SHEET
LLL0502 v5.0
en/US
Observe label precautions. Store in a dry, well ventilated place away from sources of heat, ignition and direct sunlight. No smoking.
Prevent unauthorized access. Containers which are opened must be carefully resealed and kept upright to prevent leakage.
Advice on common storage
Store separately from oxidizing agents and strongly alkaline and strongly acidic materials.
OSHA/NFPA Storage Classification: IIIB
8. Exposure controls/personal protection
Engineering controls and work practices
Provide adequate ventilation.This should be achieved by a good general extraction and -if practically feasible- by the use of a local
exhaust ventilation.If these are not sufficient to maintain concentrations of particulates and solvent vapour below the OEL, suitable
respiratory protection must be worn.
National occupational exposure limits
CAS-No. Chemical name Source Time Type Value Note
13463-67-7 Titanium dioxide OSHA 8 hr TWA 15 mg/m3 Total Dust
14808-60-7 Quartz-crystalline silica OSHA 8 hr TWA 0.3 mg/m3 Total Dust
OSHA 8 hr TWA 50 ug/m3 Respirable
Dust
Glossary
CEIL Ceiling exposure limit
STEL Short term exposure limit
TL Threshold limits
TLV Threshold Limit Value
TWA Time weighted average
TWAE Time-Weighted Average
Protective equipment
Personal protective equipment should be worn to prevent contact with eyes, skin or clothing.
Respiratory protection
Do not breathe vapors or mists. Wear an appropriate, properly fitted NIOSH approved respirator during application and until all
vapors and spray mists are exhausted unless air monitoring demonstrates vapor/mist levels are below applicable limits. If respirators
are required, use a properly fitted air-purifying respirator with organic vapor cartridges (NIOSH approved TC-23C) and particulate
filter (NIOSH TC-84A). In confined spaces, or in situations where continuous spray operations are typical, or if proper air-purifying
respirator fit is not possible, wear a positive pressure, supplied-air respirator (NIOSH TC-19C). In all cases, follow respirator
manufacturer’s directions for respirator use.‘
Eye protection
Desirable in all industrial situations. Goggles are preferred to prevent eye irritation. If safety glasses are substituted, include splash
guard or side shields.
Skin and body protection
Choose skin and body protection as appropriate for the concentration and quantity of hazardous substances, and to the specific
work-place practices.
Hygiene measures
Wash skin thoroughly with soap and water or use recognized skin cleanser. Do NOT use solvents or thinners.
Environmental exposure controls
Do not let product enter drains.
For ecological information, refer to Ecological Information Section 12.
c
 2018 Axalta Coating Systems, LLC and all affiliates. All rights reserved.
Copies may be made only for those using Axalta Coating Systems products.
4 - 9
2018-11-07