User's Guide

1. Establishing a 60GHz Network

1.1 Creating WiGig Network by MiFi’s WiGig and Adaptor

The Jaguar Wave Wireless Gigabit Adapter uses IEEE 802.11ad protocol for

connecting WiGig AP of MiFi directly to create a wireless LAN network. The

instructions for accomplishing this are listed below.

Note: Images in this document may differ slightly from those on your display.

1. Enable MiFi’s WiGig AP

a. Boot up MiFi by pressing power button for 3 sec

b. Switch to WiFi setup page (up-left of Figure 1) of MiFi by pressing MiFi power

button

c. Double press power button to set up WiGig function (up-right of Figure 1) and

then enable/disable WiGig function by double pressing power button (down-left

of Figure 1)

d. Leave WiFi setup page by double pressing button (down-right of Figure 1)

Figure 1: steps to enable WiGig AP of MiFi