User's Guide

ThingMagic Micro Family User Guide
Review Copy 11-6-10
34
www.JADAKtech.com
Communication Regulation Information
Contact [e-mail] before beginning the process of getting regulatory approval for a
finished product using the Micro.
Micro, Micro-LTE Regulatory Information
EMC FCC 47 CFR, Part 15
Industrie Canada RSS-210
Federal Communication Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Warning: Operation of the Micro module requires professional installation to correctly set the
TX power for the RF cable and antenna selected.
This transmitter module is authorized to be used in other devices only by OEM integrators under the
following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 23cm is maintained
between the radiator (antenna) & user’s/nearby people’s body at all times to meet the FCC MPE
requirement.
2. The transmitter module must not be co-located with any other antenna or transmitter.
7 Compliance and IP Notices