User's Manual

Dev Kit Hardware
A DIVISION OF TRIMBLE
Appendix B: Getting Started - Dev Kit 109
1. Connect the USB cable (use only the black connector) from a PC to the developer’s
kit. There are two
Dev Kit USB Interfaces options.
2. Plug the power supply into the Dev Kit’s DC power input connector.
3. The LED next to the DC input jack, labeled DS1, should light up. If it doesn’t light up
check jumper
J17 to make sure the jumper is connecting pins 2 and 3
4. Follow the steps based on the
Dev Kit USB Interfaces used and make note of the
COM port or /dev device file, as appropriate for your operating system the USB
interface is assigned.
5. To start reading tags start the
Demo Application (Universal Reader Assistant).
WARNING!
While the module is powered up, do not touch components. Doing so
may be damage the dev kit and ThingMagic Nano module.