User's Manual

JunoT41/5
UserManual
49
drainthebattery.
ReceivingBeams:Toallowthedevicetoreceiveincomingbeams,tap
>Settings>Connections>BeamtoopentheBeamscreen.Checkthe
ReceiveallincomingbeamscheckboxandtapOK.
CreatingaBluetoothPartnership:Bluetoothpartnershipsarerequiredfor
connectionstosomePC’s,printers,andheadphones.
ConfiguringBluetoothconnectionsvarydependinguponhoweach
Bluetoothdeviceworks.Refertoalldevicedocumentation.
1. Tap>Settings>Bluetooth>Mode.Ensurethatbothdevices
haveBluetoothturnedonintheModearea,arevisibleandwithin
closerange.
2. TapDevices>Addnewdevice…Waitafewmomentswhileyour
devicesearchesforBluetoothdevices.
3. TapthenameoftheotherBluetoothdeviceandtapNext.For
enhancedsecurity,usepasscodes.Enterthesamepasscodeonthe
otherdevice.
4. UnderAdvanced,youcanchangethenameoftheotherdeviceand
addadditionalservices,ifavailable.TapSave.
CreatingaBluetoothconnectionwithaPC:
1. EnsurethatyourPChasconnectivitysoftwareinstalledandhas
Bluetoothhardware.
2. SetupapartnershipbetweenyourdeviceandthePC.RefertoyourPC
documentationforinstructions.
3. Onceshown,selectthePCfromtheDevicelistandtapNext.
4. Enterthepasscode,ifnecessaryandtapNext.
5. ConfirmthatActiveSyncserviceisavailableandplaceacheckinthe
checkboxandtapFinish.
6. Tap>ActiveSync>Menu>ConnectviaBluetooth.
Bluetooth‐enabledheadphone:YoucanuseBluetoothstereo
headphones(A2DP)oraBluetoothheadset(HFP/HSP).AnyBluetooth
audiodevicesupportingtheA2DP,HFP,orHSPprofilesshouldbe
compatible.ManyBluetoothheadphonesdonotrequireapasscodeto