User's Guide
Table Of Contents
- THINGMAGIC M6e User Guide
- Introduction
- Hardware Overview
- Hardware Interfaces
- Digital/Power Connector
- USB Interface
- General Purpose Input/Output (GPIO)
- Power Requirements
- Special RF Power Output Requirements for the M6e-A
- Environmental Specifications
- Electro-Static Discharge (ESD) Specification
- Mounting Screw Clearance
- Assembly Information
- Antennas
- M6e Mechanical Drawing
- Authorized Antennas
- M6e-A Authorized Cables
- Firmware Overview
- New Features - Version 1.21.2
- Margin Read Support for Monza6 Tags
- NXP UCODE7 Configuration Support
- Gen2 Parameters in Metadata
- Support for Acura Gen2V2 Tags
- Support for GEN2V2 Embedded Tag Ops
- Gen2V2 Support
- Denatran Tag Support
- Configurable T4 for Gen2 Protocol
- Ability to “Read Data” Immediately After Sending a “Write EPC” or “Write Data” Command
- Decoupling Antenna Selection from AsyncOnTime
- Support for Additional Regions
- Support for Set/get Quantization Value and Minimum Frequency in Open Region
- Operational Notes
- Boot Loader
- Application Firmware
- Custom On-Reader Applications
- New Features - Version 1.21.2
- Communication Protocol
- Functionality
- Specifications
- Compliance and IP Notices
- Error Messages
- Getting Started – Development Kit and Carrier Board
- Environmental Considerations
ThingMagic M6e User Guide 60
www.JADAKtech.com
Distribution and sale of the Dev Kit is intended solely for use in future development of devices which may
be subject to regional regulatory authorities governing radio emission. This Dev Kit may not be resold by
users for any purpose. Accordingly, operation of the Dev Kit in the development of future devices is
deemed within the discretion of the user and the user shall have all responsibility for any compliance with
any regional regulatory authority governing radio emission of such development or use, including without
limitation reducing electrical interference to legally acceptable levels. All products developed by user must
be approved by the appropriate regional regulatory authority governing radio emission prior to marketing or
sale of such products and user bears all responsibility for obtaining the prior appropriate regulatory
approval, or approval as needed from any other authority governing radio emission.