User's Guide
Table Of Contents
- THINGMAGIC M6e User Guide
- Introduction
- Hardware Overview
- Hardware Interfaces
- Digital/Power Connector
- USB Interface
- General Purpose Input/Output (GPIO)
- Power Requirements
- Special RF Power Output Requirements for the M6e-A
- Environmental Specifications
- Electro-Static Discharge (ESD) Specification
- Mounting Screw Clearance
- Assembly Information
- Antennas
- M6e Mechanical Drawing
- Authorized Antennas
- M6e-A Authorized Cables
- Firmware Overview
- New Features - Version 1.21.2
- Margin Read Support for Monza6 Tags
- NXP UCODE7 Configuration Support
- Gen2 Parameters in Metadata
- Support for Acura Gen2V2 Tags
- Support for GEN2V2 Embedded Tag Ops
- Gen2V2 Support
- Denatran Tag Support
- Configurable T4 for Gen2 Protocol
- Ability to “Read Data” Immediately After Sending a “Write EPC” or “Write Data” Command
- Decoupling Antenna Selection from AsyncOnTime
- Support for Additional Regions
- Support for Set/get Quantization Value and Minimum Frequency in Open Region
- Operational Notes
- Boot Loader
- Application Firmware
- Custom On-Reader Applications
- New Features - Version 1.21.2
- Communication Protocol
- Functionality
- Specifications
- Compliance and IP Notices
- Error Messages
- Getting Started – Development Kit and Carrier Board
- Environmental Considerations
ThingMagic M6e User Guide 22
www.JADAKtech.com
The MercuryAPI supports Java, .NET and C programming environments. The MercuryAPI Software
Development Kit (SDK) contains sample applications and source code to help developers get started
demoing and developing functionality. For more information on the MercuryAPI see the MercuryAPI
Programmers Guide and the MercuryAPI SDK, available on www.jadaktech.com.