User Manual

Tag ID Buffer Faults
72 Appendix A: Error Messages
Tag ID Buffer Faults
The following table lists the common faults discussed in this section.
FAULT_TAG_ID_BUFFER_NOT_ENOUGH_TAGS_AVAILABLE –
600h
Cause
A command was received to get a certain number of tag ids from the tag id buffer. The
reader contains less tag ids stored in its tag id buffer than the number the host is sending.
Solution
Send a testcase reproducing the behavior to [e-mail].
FAULT_TAG_ID_BUFFER_FULL – 601h
Cause
The tag id buffer is full.
Solution
Send a testcase reproducing the behavior to [e-mail].
FAULT_TAG_ID_BUFFER_REPEATED_TAG_ID – 602h
Cause
The module has an internal error. One of the protocols is trying to add an existing TagID
to the buffer.
Fault Message Code
FAULT_TAG_ID_BUFFER_NOT_ENOUGH_TAGS_AVAILABLE – 600h
600h
FAULT_TAG_ID_BUFFER_FULL – 601h
601h
FAULT_TAG_ID_BUFFER_REPEATED_TAG_ID – 602h
602h
FAULT_TAG_ID_BUFFER_NUM_TAG_TOO_LARGE – 603h
603h