User Manual

Flash Faults
58 Appendix A: Error Messages
Flash Faults
The following table lists the common faults discussed in this section.
FAULT_FLASH_BAD_ERASE_PASSWORD – 300h
Cause
A command was received to erase some part of the flash but the password supplied with
the command was incorrect.
Solution
When this occurs make note of the operations you were executing, save FULL error
response and send a testcase reproducing the behavior to [e-mail].
FAULT_FLASH_BAD_WRITE_PASSWORD – 301h
Cause
A command was received to write some part of the flash but the password supplied with
the command was not correct.
Solution
When this occurs make note of the operations you were executing, save FULL error
response and send a testcase reproducing the behavior to [e-mail].
Fault Message Code
FAULT_FLASH_BAD_ERASE_PASSWORD – 300h
300h
FAULT_FLASH_BAD_WRITE_PASSWORD – 301h
301h
FAULT_FLASH_UNDEFINED_ERROR – 302h
302h
FAULT_FLASH_ILLEGAL_SECTOR – 303h
303h
FAULT_FLASH_WRITE_TO_NON_ERASED_AREA – 304h
304h
FAULT_FLASH_WRITE_TO_ILLEGAL_SECTOR – 305h
305h
FAULT_FLASH_VERIFY_FAILED – 306h
306h