User Manual

Tel: [phone]
Fax: [phone]
2 Hamelacha St., Poleg Industrial Zone, Natanya ,P.O.B 8249, ZIP 42504 Israel
LogiTag Systems LTD. www.logi-tag.com
Page
9/12
• Click OK
• Make sure you disconnect the Bluetooth connection to
the reader before starting an application which tries to
connect with it again.
• It is recommended to perform a full reset to the pocket
PC after initial definition of the reader Bluetooth port
For PC:
• Open the BT wizard and search for devices.
• Select the reader according to its BT ID number.
• Choose "use the device ID" and insert password 1234
• Check which COM ports numbers the BT device
received. See at the BT wizard which is the "outgoing"
comport.
• To activate software, configure comport parameters and
choose the outgoing comport.
4. Place the reader on your belt facing front.
5. Choose command Read tags, and when you are in front of
transponder run the command.
6. If transponder identified the ID number will appear on screen.
7. Repeat the command whenever needed.
8. While the system is at battery charging, do not use it or connect to
pocket PC.