Installation Guide

SHOWER SEAT INSTALLATION INSTRUCTIONS
PLEASE READ THESE INSTALLATION INSTRUCTIONS THOROUGHLY PRIOR TO INSTALLING THIS SHOWER SEAT
IMPORTANT: THIS PRODUCT SHOULD ONLY BE INSTALLED BY QUALIFIED AND TRAINED PERSONNEL
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD LEAD TO IMPROPER INSTALLATION OF THE SHOWER SEAT,
STRUCTURAL AND/OR WATER DAMAGE TO THE WALL AND IN-WALL SUPPORT STRUCTURES, AND/OR SERIOUS BODILY
INJURY IN USE. IN ADDITION, ALL WARRANTIES, EXPRESS OR IMPLIED, WILL BE NULL & VOID DUE TO IMPROPER INSTALLATION OF
THIS PRODUCT. THE MANUFACTURER DOES NOT ASSUME ANY LIABILITY FOR DAMAGE RESULTING FROM
SERVICES PERFORMED BY OTHERS, OR FAULTY INSTALLATION, MISUSE OR MISAPPLICATION OF GOODS.
TO ASSURE PROPER AND SAFE INSTALLATION, THIS SHOWER SEAT MUST BE INSTALLED INTO A MINIMUM 2” THICK SOLID WOOD
IN-WALL BACKING MATERIAL. MAKE CERTAIN IN-WALL BACKING COMPLIES WITH ALL LOCAL BUILDING CODE REQUIREMENTS.
STEP #1 LOCATING
• Remove Shower Seat from package.
• Locate the area with 2" solid wood in-wall backing on the desired mounting surface.
• Place the mounting bracket in position on the wall. Using a level (not provided) ensure the bracket is level and pencil-mark
the location of the mounting holes on the wall.
• Using a pencil or suitable marker, it is extremely important you mark the center of each of the five (5) mounting holes
precisely on the mounting surface.
Hardware Provided: (5) M8 x 60mm Phillips Head Screws
Tools required: Marking pencil/pen, level, power drill,
17/64” carbide tip drill bit, #2 Phillips driver, silicone.
Proceed cautiously through the following steps in this installation process to avoid drilling into in-wall water supply lines.
All mounting points must fasten into structural wood backing, minimum 2” thickness. Avoid electrical and/or plumbing
behind the wall, and where possible drill through tile - not through grout.
STEP #2 MOUNTING
FIG 2.1
Use a power drill with a 3/16” carbide tip drill bit (not
provided) and drill at the five (5) locations marked on the wall.
FIG 2.2
Apply a bead of silicone around the entire edge of the Shower
Seat mounting bracket and inside each of the pre-drilled holes
to ensure a water-tight seal will be created at all mounting
locations. Secure the Shower Seat to the wall using the
supplied screws by screwing them into the pre-drilled and silicone
filled holes.
FIG 2.3
Fasten the Shower Seat to the mounting bracket using the
provided connection bolts and ensure that the seat can be
moved alone the guide channel on the mounting bracket.
Questions, problems, missing parts? Before
returning to your retailer, call our customer service
department at 1-800-288-4002, 9 a.m. - 8 p.m.,
EST, Monday - Friday
Jacuzzi® Model #
SS17959
FIG 2.1
FIG 2.2
FIG 2.3