Installation Guide

3
Drill a hole 2 1/4 in. diameter min. - 2 9/16 in. diameter
max. in the floor with an electric drill (1).
Lower the filler assembly over the hole and mark the
locations for the screws with a pencil (2). Then drill
four holes 1/4 in. diameter for the screws in the floor
with an electric drill (1).
Insert the spout (1) into the faucet assembly (2).
Rotate the spout (1) to align correctly with the faucet
assembly (2) then tighten the set screw using hex
wrench (3). Once the spout is aligned and
tightened, it is not designed to be rotated.
Rotating may cause the set screw to loosen.
Check to ensure that the pre-installed set screw
at the valve is tightened.
Note 1: If installing in concrete the Freestanding Tub
Filler Rough-in Manifold Kit (PT61000) is required.
Note 2: If using PT61000 Rough-in Manifold Kit please
skip to step 6A after the Rough-in Manifold Kit has
been installed.
Insert supply hoses (1) through cut out hole drilled
into floor / tile.
Tighten the hose (1) into hot and cold water supply (2)
using wrench.
Secure stand pipe (3) using screws (4) and anchors (5).
Do not use anchors (5) if securing into a wood floor.
After installing, cover the floor (6). Continue to step 6.
Screw the connectors (1, contained in SKU# PT61000)
into faucet assembly using allen wrench .
Cut a section of floor to run the plumbing as shown in
the diagram.
ASSEMBLY INSTRUCTIONS
3
4
1
1
1
1/4 in. dia.
Floor
1/4 in. dia.
5
3
Front
Min. 280mm
Min. 110mm
210mm~230mm
Min. 280mm
Min. 110mm
Min. 110mm
Floor
3
6
4
5
1
2
6A
1
2
Min. 3 in.
(76.2mm）
WARNINGS:
• DURING INSTALLATION OR SERVICE DO NOT
TWIST OR KINK EITHER HOSE OR LEAVE HOSES
IN THIS INSTALLED CONDITION.
The hoses are under water pressure, and this can
cause damage and flooding.
• DO NOT OVERTIGHTEN HOSE CONNECTION TO
WATER SUPPLY.
This can cause damage to nut, connector, valves and
faucet and can cause flooding.
• REPLACE HOSE IF ANY DAMAGE IS VISIBLE.
• DO NOT REUSE HOSE.
• Manufacturer assumes no liability for failure due to
improper installation, and use.
2
Attach the supply lines (1) to the faucet assembly (2)
using wrench. Do not overtighten.
Note: Do not reverse the hot and cold supply lines.
2
Front
Hot inlet
supply line
Cold inlet
supply line
2
1