User Guide

ManualsBrandsJacuzzi ManualsOtherPOST AND RAIL STYLE SKIRT INSTALLATION INSTRUCTIONS

Lay the bottom rail on the floor between the two vertical

posts. Locate the front surface of the bottom rail 5/8"

behind the front surface of the vertical posts as shown in

illustration 3. Fasten the bottom rail to the floor using the

screws provided.

With isopropyl alcohol, clean an area 2" long (6 places)

on the rail and bottom edge of the skirt. These locations

should be at the center line and 12" from each end of

both parts; (see illustration 4.) Remove liner from

adhesive backing and apply the strips of Velcro

hook

tape to the bottom rail, 12" from each end and in the

center, as illustrated. Apply strips of Velcro

loop tape to

the bottom of the skirt, 12" from each end and in the

center, so that they will attach to the bottom rail when the

skirt is installed.

Lift the top of the skirt up under the rim of the bath, center

the skirt in the opening, then swing bottom of skirt toward

the rail and lower skirt onto rail. The Velcro

on the skirt

and the bottom rail should mesh.

Printed on Recycled Paper

Printed in the U.S.A.

SCREW

BRACKET

WOOD BLOCK

AT CORNER

OF BATH RIM

POST

(Right Hand

side shown)

SPEED

NUT

FIXED SIDE

PANEL

5/8"

BOTTOM

RAIL

BOTTOM

RAIL

SCREWS

(PROVIDED)

FIXED SIDE

PANEL

REMOVABLE SKIRT

BOTTOM RAIL

VELCRO

LOOP

TAPE

CENTER OF RAIL

12"

HOOK TAPE

LIFT TOP OF

SKIRT UP

UNDERNEATH

RIM OF BATH

INTERLOCKING

VELCRO

TAPES

SHELL CLIP

WOODEN

BLOCK