SHOWER BASES INSTALLATION AND OPERATION INSTRUCTIONS Jacuzzi Luxury Bath 14525 Monte Vista Avenue Chino, CA 91710 1-800-288-4002 www.jacuzzi.
English Contents Contents........................................................................................................................................................................... 2 Product Information.......................................................................................................................................................... 2 Shower Base Installation Instructions.................................................................................................
1 Remove the shower base from the carton. Do not destroy the shipping carton until after satisfactory inspection of the product. Should initial inspection reveal any damage or defect in the shower finish, do not install the shower base. Jacuzzi Luxury Bath’s responsibility for shipping damage ceases upon delivery of the product in good order to the carrier. Refer any claims of damage to the carrier. Any damage or defect claimed after installation is excluded from the warranty.
English Shower Base Installation Instructions (Continued) Install the shower drain in accordance to the drain manufacturer's recommendations, see Figure 2. Position and install the shower base over the drain, see Figure 2. With the drain fitting passing over the center of the drain pipe, lower the shower base carefully into place. Push down firmly until the base is in place. Check the level of the base in two directions, see Figure 3. 4 Figure 2 Figure 3 Install drain before lowering into place.
Replace the strainer, if your drain kit came with one, and tape over the drain 7 hole to prevent finishing material from entering the drain. Place a cement board or equivalent on top of the shower base flange and secure to studwall, see Figure 5. 8 Cement board Apply tile, or other finishing material, leaving a 1/8” gap between the finishing material and the flange lip of the shower base, see Figure 7. Seal this gap with a silicone sealant.
English Clean Up After Installation • The acrylic finish will give long-lasting beauty when properly maintained. To avoid dulling and scratching of the finish, never use abrasive cleaners or harsh chemicals. A mild liquid detergent and warm water will clean soiled surfaces. • Remove spilled plaster with a wood or plastic edge. Metal tools will scratch the surface. Spots left by plaster or grout can be removed if lightly rubbed with a mild detergent and a damp cloth or sponge.
WARRANTY COVERAGE Jacuzzi Luxury Bath (“Company”) offers the following limited warranty to the original purchaser of any Jacuzzi Luxury Bath acrylic shower base (“unit”) who purchases the product for personal or single family use (“user”). Company will repair or replace, at its option, the unit or options and accessories referenced below in accordance with the following terms and conditions. Units in commercial use are excluded from any warranty coverage whatsoever.
RESPONSIBILITIES OF OTHERS Inspecting the unit prior to installation is the responsibility of the installer or building contractor who acts on behalf of the user. They are responsible for ensuring the unit is free of defect or damage. Notices are placed on and in the unit and on the shipping carton advising the installer of this responsibility. In the event of a problem, the unit must not be installed.
