Installation Guide
Page 14 www.jacuzzi.com Installation and Operation
Collection Comfort
English
Clean the whirlpool suction cover/strainer of hair and debris
when necessary (Figure 17).
1. Insert and push at head screw driver into the center of the
suction cover and remove cover.
2. Clean the cover by backushing debris from the holes.
3. Replace the suction cover immediately after cleaning.
WARNING: Keep hair a minimum of 6.00" (152 mm) away
from the suction tting at all times when the whirlpool
system is operating. Hair longer than shoulder length
should be secured close to the head, or a bathing cap
should be worn.
WARNING: Do not operate the whirlpool system with the
suction cover/strainer removed! It is a safety device and must
always be in place on the suction tting to minimize the
potential hazard of hair and body entrapment.
Fig. 17
Flat Head Screw
Driver
Suction Cover
Cleaning And Maintenance (Continued)
Whirlpool Suction Cover/Strainer Maintenance