Installation Guide
Page 12 www.jacuzzi.com Installation and Operation
Collection Comfort
English
®
ON: Press the button once to turn the blower ON. The blower will start
on high speed (on rst use).
OFF: Press the button a second time to turn the blower OFF.
The last blower setting used is remembered by the system and will
automatically resume upon next use.
Press the button to increase blower speed.
There are ve blower intensities. Each push and release of the button will increase blower intensity through ve
incremental steps.
Alternately, if the button is depressed and held, the blower intensity will increase through each of the 5 blower
intensities, stopping when the button is released.
Press the button to decrease blower speed.
There are ve blower intensities. Each push and release of the button will decrease blower intensity through ve
incremental steps. Alternately, if the button is depressed and held, the blower intensity will decrease through each
of the five blower intensities, stopping when the button is released.
Fig. 15
PureAir® Operation (Figure 15)
Blower Operation
Increase Speed
Decrease Speed
The blower will operate for 20 minutes and then automatically shut off, unless power is manually turned off. In either
case, 20 minutes after the blower has shut off, it will turn ON for a one-minute drying cycle to blow out any water
remaining in the air system.
If the bath is used without the blower operating (showering or bathing without using the PureAir® system), initiate the
one-minute drying cycle manually by use of the ON/OFF switch. Turn the switch ON and OFF again as you exit the
bath and the drying cycle will occur in 20 minutes.
To Acitvate: Holding the button for ve-seconds when the blower is off activates the daily purge. The blower will
start every day at the same time for one-minute. Once the daily purge is activated, the blower will come on for one-
second, turn off for two-seconds, come on for one-second and then turn off.
To Deactivate: Holding the button for ve-seconds when the blower is off deactivates the daily purge. When the
daily purge is deactivated, the blower will come on for one-second and then turn off.
Purging the PureAir® System
Daily Purge
Purging the Whirlpool System
To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub
be cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub
after each use using Systems Clean™, our exclusive two-part plumbing system cleaner made specically for
whirlpool bathtubs. Systems Clean™ is available through an authorized Jacuzzi Luxury Bath distributor, by calling
1-800-288-4002 or may be purchased online at www.jacuzzi.com.