Installation Guide
Page 10 www.jacuzzi.com Installation and Operation
Collection Comfort
English
This skirt installation method is used for select bathtubs only. All other Comfort Collection bathtubs utilize magnets to
secure skirt panels.
To remove the skirt panel -
Grasp an edge of the skirt panel and pull to separate.
To reinstall the skirt panel (Figure 9) -
Align the six posts on the panel with the six receptor sockets on the tub and press
into place.
Skirt Panel Adjustment (Figure 10) -
Insert a standard screwdriver into the receptor socket through the slot at the rear.
Turn clockwise to tighten and counter-clockwise to loosen.
All bathtubs manufactured by Jacuzzi Luxury Bath are designed for “ll
and drain,” which means the bathtub should be drained after each use
and lled with fresh water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water continuously like pools
or spas.
Close the drain and ll the bathtub until water is at least 1˝ to 2˝ (25mm
to 51mm) above the highest jet or air inlet (see water line indicated in
the illustration - Figure 11). Do not turn on the whirlpool or PureAir®
system at any time if the jets or air inlets are not completely immersed
in water. Running the whirlpool or PureAir® system when there is
insufcient water in the bathtub could result in water spraying outside
the bath area.
When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed out
of the unit. To prevent this, you must turn unit OFF before exiting bathtub.
Fig. 11
Fill to at least 1˝ to 2˝
above highest jet
Installation Cleanup
General Operation Information
•
Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbed
with detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as they
will damage the bathtub’s surface.
•
Paint, tar, or other difcult stains may be removed with Fantastik® cleaner or soapy water.
•
Minor scratches which do not penetrate the color nish can be removed by lightly sanding with 600-grit wet/
dry sandpaper. You can restore the glossy nish to the acrylic surface of the bathtub with a special compound,
Meguiar’s #10 Mirror Glaze. If that is not available, use automotive rubbing compound followed by an application
of automotive paste wax.
•
Major scratches and gouges which penetrate the acrylic surface will require renishing. Call Jacuzzi Luxury Bath
to nd a service agent in your area.
Fig. 9
Receptor Socket
Post
Fig. 10
Interior View
Exterior View
Receptor Socket Slot
Skirt Panel Installation (Select Skirted Models Only)