Installation & Assembly

Soaker™ Bath Series
Installation and Operation www.jacuzzi.com Page 7
English
Suboor
Preparethesuboorforthedrainandensurethattheareaislevel.
1
 Thedrain/overowofthebathtubextendsbelowthebottomofthebathtub.IdentifythedrawingintheTechnical
SpecicationsManualthatcorrespondswithyourbathtub.
2
 Makeappropriatecutstothesuboortoaccommodatethedrain.
3
 Jacuzzi’sTru-Level™baseisastandardfeatureonallbathtubs.Ifthesuboorislevelandacontinuoussurface,
no other preparation is necessary. Proceed to the “Installation” section.
4
 Ifthesuboorisnotlevel,youmustleveltheentiresurfacepriortoinstallingthebathtub.Thematerialsused
will insure that the bathtub is supported from the bottom. These materials include: leveling compound, mortar,
plaster or minimal expansion structural foam (having a density of a minimum 5lbs/cubic foot). The bathtub must
remain level in order for it to drain properly and must make contact with the leveling material. Both sides of a joint
orspliceofsuboorshouldbeleveltoeachother.
Electrical Connections (Soakers with Chromatherapy Only)
Risk of electric shock. Connect only to a circuit
protected by a GFCI.
When using electrical products, basic precautions
should always be followed:
•
Always follow local building and electrical codes.
•
For soakers with chromatherapy, grounding is
required. The unit should be installed and
 groundedbyaqualiedelectrician.
A 120V, 15A, GFCI protected circuit is required. Install a
duplex outlet to the wall stud underneath the bathtub, at
least4˝(101mm)abovetheoor.Theduplexoutletisnot
supplied.
Reset
Test
Chromatherapy Light Installation
Your bathtub comes with two lights, cables, and control
box (pre-installed). The control panel requires installation
in a location selected by the installer.
1
Plan the location of the control panel. A possible
congurationisshownatright(Figure2).
The panel cannot be immersed in the bathtub
water.Selectalocationatleast1˝abovethelevel
oftheoverowdrain.
 Thecontrolpanelmustbeinstalledonaatsurface
atleast3˝widex2˝tall.Youmaymountonanyat
surface on the bathtub shell, bathtub surround or
on the adjacent wall.
The control cable has a length of 10’. If you plan to
remote-mount the control panel (not on the bathtub
deck), the control panel cannot be located more
than 10’ from the control box.
Figure 2 - Possible Conguration
Chromatherapy
Lights
Control Panel