Installation & Assembly

Soaker™ Bath Series
Page 6 www.jacuzzi.com Installation and Operation
English
Inspection and Testing
Visual Inspection
1
Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed
staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the
product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.
2
 Inspecttheshellandbathtubcomponents.Shouldinspectionrevealanydamageordefectinthenishorvisible
damagetoanycomponents,donotinstallthebathtub.Damageordefecttothenishclaimedafterthebathtub
is installed is excluded from the warranty. Jacuzzi Luxury Bath’s responsibility for shipping damage ceases upon
delivery of the products in good order to the carrier.
3
 Referanyclaimsfordamagetothecarrier.Fordenitionsofwarrantycoverageandlimitations,refertothe
published warranty information packed with the product or in the back of this manual.
Installation
Atechnicalspecicationsmanualhasbeenincludedwithyourbathtub.TheTechnicalSpecicationsManualwill
containpertinentinformationregardingyourJacuzziLuxuryBathproduct.LocatetheTechnicalSpecicationsManual
at this time.
Figure 1 - Common Access Location
Framing
•
Dimensions provided on rough-in diagrams are nominal.
Measure your actual unit upon receipt and build
according to the actual dimensions.
•
Theoorstructurebeneaththebathtubmustbeableto
support the total weight of the bathtub, water and bather.
 PleaserefertotheTechnicalSpecicationsManual
(column marked ‘Total Weight/ Floor Loading’).
•
The unit must be supported from the bottom of the
bathtub and not from the bathtub rim. For drop-in
installations, take into account the thickness of the
 surroundmaterialandnishingmaterial(marble,tile,
etc.).
•
Ensure the rim will rest on a level surface.
•
Per code, access must be provided to the chromatherapy
control panel box (if equipped). Service access
locations are shown in the rough-in diagrams contained
 intheTechnicalSpecicationsManual(Figure1).
It is the responsibility of the installer, building
contractor, or owner to provide access for service.
Jacuzzi is not responsible for any costs relating to
obtaining access for repair. The owner shall bear such
costs and, if appropriate, must seek recovery from the
installer.
Frame out the space where the bathtub is to be located. The
following should be taken into consideration when preparing
the area:
OVERFLOW
F
CHROMATHERAPY
LIGHT LOCATIONS