Installation Guide

Drain Information.
NOTE: Watertight installation of the drain is the
installer's responsibility. Any occurrence of drain
leakage is excluded from the Jacuzzi Whirlpool Bath
warranty coverage of this product.
CAUTION: A nonflammable protective barrier must
be placed between soldering work and shower unit
to avoid possible damage to the bath.
Clean-Up After Installation
To avoid dulling and scratching the surface of the
shower, never use abrasive cleaners. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge.
Metal tools will scratch the surface. Spots left by plaster
or grout can be removed if lightly rubbed with detergent
on a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with
paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol).
Minor scratches which do not penetrate the color
finish can be removed by lightly sanding with 600-grit
wet/dry sandpaper. You can restore the glossy finish to
the acrylic surface of the bath with a special compound,
Meguiar's #10 Mirror Glaze. If that is not available, use
automotive rubbing compound followed by an applica-
tion of automotive paste wax.
Major scratches and gouges which penetrate the
acrylic surface will require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
STRAINER
DRAIN
ASSEMBLY
SILICONE
SEALANT
SHOWER
BASE
RUBBER WASHER
FIBER WASHER
NUT
APPLY
LUBRICANT
DRAIN ASSEMBLY
Remove the stainless steel strainer from the drain
assembly. Disassemble the locknut and two gaskets
from the back of the drain assembly. Apply a 1/4" bead
of caulking (silicone) to the drain hole and insert the drain
assembly. Replace the rubber washer, fiber washer,
and lock nut in that order. Hand tighten the locknut.
Remove excess sealant from finished side. (See illustra-
tion).
Apply a lubricant (common household liquid soap
works well) to the inside of the rubber seal of the drain
assembly.
TIGHTEN SEALING NUT
TOOL
(INCLUDED)
With a large screwdriver and the tool included with the
drain, tighten the inside compression nut to seal the
drain pipe connection. Replace the strainer and tape
over the drain hole to prevent finishing material from
entering drain.
©1997 Jacuzzi Whirlpool Bath M545000 8/13/04
Jacuzzi Whirlpool Bath
P.O. Box 702168, Dallas, TX 75370-2168
Service Support: Call [phone]
Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of
this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product.
Jacuzzi Whirlpool Bath makes no representation or warranty regarding, and will not be responsible for any code compliance.
PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.
Printed in the U.S.A.
Printed on Recycled Paper
4