Installation Guide

Important: Read complete instructions before beginning installation.
Remove the shower from the carton. Retain the shipping carton until satisfactory inspection of the product has been
made. Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect
in the finish, do not install the shower. Damage or defect to the finish claimed after the shower is installed is excluded
from the warranty. Jacuzzi Whirlpool Bath’s responsibility for shipping damage ceases upon delivery of the products
in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and
limitations, refer to the published warranty information packed with the product.
All shower units are factory tested for watertight connections prior to shipping. Jacuzzi Whirlpool Bath is not
responsible for any defect that could have been discovered, repaired, or avoided by following this inspection.
Install the optional trim parts when all installation has been completed.
HEADER ON EDGE
BLOCKING REQUIRED IF UNIT
IS INSTALLED IN SECTIONS
10-1/2" x 5"
DRAIN CUT-OUT
90º
16"
33-1/4"
90º
26"
32"
21"
83"
62"
26"
1x2
12"
60-1/4"
FRONT OF DOUBLE STUDS
SUB-FLOOR
FRAMING DETAILS (Right Hand Shown)
2