Installation Sheet

ManualsBrandsJacuzzi ManualsPlumbingAmalia 59" Free Standing Soaking Tub with Center Drain, Drain Assembly and Overflow

Table Of Contents

English

Page 6 www.jacuzzi.com Installation Instructions

Freestanding Baths

Overow Drain Hole Cutouts

Cutout (Fig. 4) Drain Part Number

Linear Drain MF35XXX

Rotary Drain HP55XXX

Avvio Collection Integral

Deep Soak Drain LH33XXX

Slip Cover Drain PG35XXX

Fig. 3

0.63”

(16mm)

0.38”

(9.65mm)

0 2.5”

(63.5mm)

3.5”

(88.9mm)

MF35

HP55

PG35

SOLID

SURFACE

LH33

3.13” (79.5mm) Minimum

4.75” (120.6mm) Maximum

Set the 2-piece tub in place and position

it precisely with respect to the drain-

overow location. Verify where the

indentation for the drain is in relation

to the drain-overow. Use a marker to

outline the perimeter of the entire tub

directly on the oor (Fig. 5).

Mark a trough for the overow drain

location on the oor. The drain-

oveow extends below the

bottom of the bath. The drain-

overow requires a cutout of the oor

for providing space to accommodate

the extension. Do not exceed the

dimensions of the tub perimeter.

When the above locations have been

marked on the oor, remove the

tub base (skirt), set it aside and

continue with the installation process.

Faucetry is not supplied with the

freestanding bath. To use deck-

mounted faucetry, exible connection

lines that are 72” in length must be

used. These lines need to be installed prior to installating the bath into the skirt.

When installing the faucet on the same side as the overow, make sure there is no interference between the two before

drilling.

Use silicone to attach the tub skirt to the Sub oor. Make sure the tub is properly oriented according to the drain-overow

end. Place the tub skirt on the oor in relation to the drain/overow. Place the tub skirt on the oor an line up with the

markings prevously made on the oor.

Apply silicone to the foam feet or bottom of the adjustable feet. Carefully place the tub into the tub skirt in relation to the

drain/overow. Allow silicone to dry for 24-hours before entering and/or using the tub.

Fig. 4

Side

Views

Bottom

Views

Silicone

Installation Instructions for 2-Piece Tub

Fig. 4

Fig. 5